When buying a blade, don't always pursue branded goods. It is best to buy a suitable electrical isolation switch (set in front of the electric control cabinet), press the EMERCENCYSTOPRESET and READYTORUN buttons, the key to open MACHINE to RUN (on the main console) check voltage (380V), the current is correct, stable. Open the hydraulic system power switch (set on the main hydraulic drive frame), check that the main hydraulic drive system oil level and pressure gauge display is correct and stable.

 

Open the pneumatic shut-off valve (set on the intake pipe under the pneumatic control cabinet), check that the air pressure is correct (not less than 6.0 bar), and stabilize. Set the slitting menu according to the type, thickness, length, width, etc. of the film arranged in the slitting plan.

 

Lift the corresponding BOPP film file from the PDF. Set the winding length and width of the film of the corresponding specification. Select the corresponding winding station, adjust the pressure roller arm and pressure roller, and install the paper core of the corresponding specification.

 

Loading: According to the requirements of the cutting plan, according to the driving operation rules, according to the actual situation, the corresponding mother roll is hoisted on the aging frame, placed on the unwinding frame of the slitting machine according to the inner and outer selection direction of the corona surface, and the control button is used. Clamp the steel core, leave the steel core support arm and drive.

 

Film penetration: When there is no film on the slitter, the film must be penetrated. Using the slitting machine through the membrane device and the function keys, one end of the original membrane is attached to the membrane chain eyelet, and the membrane button is activated to distribute the membrane along the slitting process to be evenly distributed on each roller.